Your wireless connection may have a shorter range or a slower speed through walls made of non-porous materials.Įlevators block Wi-Fi signals significantly. Wi-Fi signals will not penetrate metal enclosures. Metal is most problematic when it is in close proximity to the access point as it may also affect the radiation pattern of the antennas. Transmission through building structures that have continuous walls that are lined with metal coatings or foil may be extremely limited (such as Structural Insulated Panels ). These can include anything with metal framing, like ductwork, electrical panels, metal roofs, mirrors, cubicle walls, metal furniture, or less obvious materials like concrete or stucco that are reinforced with metal mesh. Metal structures reflect and scatter Wi-Fi signals. Calix recommends following these guidelines when optimizing your Wi-Fi signal path:
Understanding these variables and building your network with an awareness of the effects of physical obstructions will minimize problems in this area. RG Placement, Orientation, and Turn-up details common building materials and their effect on Wi-Fi signals. To maximize range and reception, it is helpful to know what structures and materials affect Wi-Fi signals. An overly sensitive receiver also picks up more interference, so there is a balance point where transmit power and receiver sensitivity are optimized for a specific application whether it be in a business environment or a subscriber’s home. Transmit power can only be increased so far due to FCC limits, in which case most access points operate at the maximum power legally allowed by the FCC for transmission. Some of these factors are built into the hardware of the receiving and sending devices, such as power amplifiers on transmitters to boost power, and low noise amplifiers on the receivers to make them more sensitive. The amount of distance, or range that can be tolerated between an access point such as the GigaCenter and any client device is affected by several factors. There are essentially two factors that affect signal attenuation between the access point and the client, and those are range (or distance), and attenuation due to obstructions. Eventually, connectivity is lost when the signal becomes too weak. This signal attenuation subsequently causes the radio to be less effective and throughput suffers. Wi-Fi signals experience attenuation due to distance from their source just like any other radio. There are many reasons why your wireless network may not be optimized, causing performance to suffer. Understanding your GigaCenter Fiber Optic Network Terminal (ONT) ♼heck the cables plugged into the ONT – make sure all cables are tightly plugged into the proper port and check for any damage to the cables.
♼heck the lights on the side of the ONT – are any lights red? If so, please contact our office at 83. The first steps in troubleshooting your fiber optic connection are:
Troubleshooting your Fiber Optic Connection and Wi-Fi
0 kommentar(er)
